Skip to Content

SEA & SEA-YS-D3 DUO Strobe - Gold

Specifications
  • [Guide Number] : 33, 28 (with Diffuser attached)
  • [Beam Angle] : 80°x105° (without Diffuser), 100°x110°(with Diffuser)
  • [Usable Batteries] : 4xAA A: 6V Ni-MH: 4.8V
  • [Number of Flashes *1] : A: 140 Ni-MH: 220
  • [Recycle time (full) *2] : A: 3.5 sec. Ni-MH: 1.7 sec.
  • [Color temperature] : 5800K (w/diffuser 5500K)
  • [Depth rating] : 100m / 330ft
  • [Color]:Gold / Red / White (Limited color)
  • [Dimensions (WxHxD)] : 92x111x147mm / 3.6 x 4.4 x 5.8 inches (excluding ball base)
  • [Weight] : 610g / 21.5oz (w/o batteries) (excluding ball base)
  • [Underwater weight] : Approx.-20g / -0.7oz (incl. batteries ball base)
  • [Others]
    Exposure control: DS-TTL II, Light level control dial (GN): 1 / 1.4 / 2 / 2.8 /4 / 5.6 /8 / 11 / 16 / 22 / 33 (11 steps)
    Pre-flash cancel function
    Auto power OFF function
    Sync cord: 5-pin Sync cord/N, Fiber-Optic Cable
    Over-pressure relief valve
    LED target light (output is adjustable in 2 steps [300lumen/150lumen])
    Audible charge signal
  • [Set Items] Ball Mount Strobe Adaptor、Diffuser、Silicon grease, Hex wrench, diffuser strap, rubber cap for fiber optic socket
  • *1 Number of flashes and recycle time depends on the battery brand, temperature and frequency of use.
    *2 Number of flashes and recycle time of Ni-MH batteries were tested on 1900 mAh batteries.

    CAUTION
    * Use of genuine SEA&SEA Fiber-Optic Cables is recommended. SEA&SEA strobes may not function properly if a third-party Fiber-Optic Cables are used (functions such as TTL auto exposure in particular).

    *Do not use non-recommended batteries (such as lithium primary batteries). Use of non-recommended batteries may cause battery leakage and overheating and may cause the strobe to rupture, which could result in personal injury.
4,500.00 4,500.00


Internal Reference: 03129

Recently Viewed

Your Dynamic Snippet will be displayed here... This message is displayed because you did not provide enough options to retrieve its content.